Cuisinart MG-50 Quick Reference Manual

QUICK REFERENCE GUIDE
Meat Grinder Attachment
ASSEMBLY
Assemble the meat grinder attachment prior
to attaching to the stand mixer.
1. Insert the feed screw pin into the open end
of the attachment.
2. Place the cutter with the flat side facing out
toward you over the feed screw pin (this is
an important step or the meat grinder will
not work).
ATTACHING TO STAND MIXER
1. Make sure stand mixer
is OFF.
2. Gently pull port cover
off front of mixer head
to remove.
3. Turn the stand mixer
attachment knob
counterclockwise
until outlet opening
is unobstructed.
4. Insert the assembled
grinder attachment into
the outlet opening, lining
up the square metal hub
on the grinder with the
square indentation in the
outlet opening.
3. Place the grinding plate over the cutter on
the feed screw pin.
4. Screw on the ring nut by turning it
clockwise and hand tighten.
When you are finished meat grinding, and if
the ring nut is too tight to remove, use the
wrench to loosen.
NOTE: To avoid damage to the meat grinder
attachment, do not use food pusher/wrench
to tighten ring to grinder body.
5. Turn the stand mixer
attachment knob
clockwise to secure
grinder to mixer.
6. Fit the tray onto the top
of the meat grinder and
put a mixing bowl under
the grinder to catch food.