Rear Panel I/O Ports
USB 3.0
DC-in
VGA
HDMI
The rear panel I/O ports consist of the following:
•
1 DC-in
•
1 VGA (default) or DP++ (optional)
•
1 HDMI (default) or DP++ (optional)
•
4 USB 3.0
•
2 GbE (RJ-45)
•
1 Line-out
Chapter 2 Hardware Installation
Chapter 2
USB 3.0
LAN 1 LAN 2
Line-out
12V DC-in (AL171)/15~36V (AL173)
DC-in
This jack is considered a low power solution. Connect a DC power cord to this jack. Using a
voltage more than the recommended range may fail to boot the system or cause damage to
the system board.
The DC-in jack on the system board co-lays with a 4-pin right angle connector (optional) or
4-pin vertical type connector (optional) as the photo displayed below.
4-pin Right Angle
(optional)
17
4-pin Vertical Type (optional)
DC-in (default)
www.dfi .com