Huawei HES-319M Installation Manual page 36

7. At your computer, open a web browser.
8. In the browser address bar, enter the URL of the WMI.
The WMI login window opens.
9. Enter the WMI Username and Password.
(Login as a guest.)
10. Click OK.
The System Status window opens.
11. Scan to the bottom of the window and locate the Device Status and Connection Status parameters.
12. Confirm that Device Status is Connected and Connection Status is Normal or Idle.
This confirms that the CPE is communicating with the base station.
If Device Status is Ready, Scanning, or Connecting, then the CPE is searching for a base station. Do not
continue until Device Status is Connected. If Device Status is not yet Connected, then Connection Status
can be Disconnected, Network Search, or Network Entry.
13. If Device Status does not go to Connected, rescan for base stations:
a. Mouse over the Maintenance icon.
b. Click Reboot.
c. When the Reboot window opens, click Reboot.
d. Wait about two minutes for the CPE to reconnect with a base station.
If Device Status does not go to Connected:
i. Check all cables and connectors between your computer and the ODU.
ii. At the ODU, rescan for base stations and confirm that one or more LEDs are on.
iii. At the WMI, if Device Status is still not Connected, contact the Dealer Support Group: 1–866–841–
6004.
14. When Device Status is Connected and Connection Status is Normal or Idle, compare the channel
bandwidth of your customer's rate plan with the bandwidth of the base station, which is indicated by the
Frequency parameter.
For a 5MHz channel, the last three digits of Frequency are 500 (for example, 3520500).
For a 10MHz channel, the last three digits of Frequency are 000 (for example, 3520000).
If the channel bandwidth's are different, contact your Dealer.
15. Locate the Signal Strength and Link Quality parameters.
16. At the WMI and ODU: While monitoring the Signal Strength and Link Quality levels, move the ODU to the
position that provides the best levels.
17. Compare the Signal Strength and Link Quality levels with the minimum acceptable levels for the rate plan
to which your customer has subscribed. Remember to select the QoI table with the correct channel
bandwidth.
HES-319M Installation 36