D-Link DSL-2642B User Manual page 67

Section 3 – Configuration
Filters Description
Parameter
Filter Name Enter a name for the new filter.
Protocol Select the transport protocol (TCP and UDP, TCP,
UDP, ICMP or Any) that will be used for the filter rule.
Source/ Select either Single IP, Network IP or IP Range to
Destination show different items.
IP Type
Source/Destination
IP Address
Source/Destination
IP Address &
Source/Destination
Subnet Mask
Start/End
Source/Destination
IP Address
Source/ The Source/Destination Port is the TCP/UDP port on
Destination either the LAN or WAN depending on if you are
Port configuring an Outbound or Inbound Filter rule.
WAN Select the WAN interfaces you want to apply for this
Interface rule.
D-Link DSL-2642B User Manual
This is the single IP address
which you are creating the filter
rule.
This is the Network IP address
and its associated subnet for
which you are creating the filter
rule.
Enter the start and end IP address
for the range of IP addresses
which you are creating the filter
rule.
66