Eaton 9140 User Manual page 24

INSTALLATION
20
Eaton 9140 EBM User's Guide
5. Secure the rail to the rear of the rack with four M5 machine screws
and an adapter plate (see Figure 4).
Tighten all screws at the front and rear of the rail.
Bottom of Rack
or Top of Other
Cabinet
Figure 4. Securing the Rear Rail (Right Rail Assembly Shown)
6. Repeat Steps 3 through 5 for the other rail.
7. To tighten the rail adjustment, assemble four M4 machine screws
and four M4 locknuts to the middle of the rail assembly. Tighten
using a 7 mm (9/32") nut driver. See Figure 5.
Repeat for the other rail.
M4 Screws
Figure 5. Tightening the Rail Adjustment (Right Rail Assembly Shown)
S 164201623 Rev C www.eaton.com/powerquality
Adapter Plate
Position 6
Position 1
Position 5
Position 4
Position 3
Position 2
M4 Locknuts