Loading Replacement Rolls; Troubleshooting The Dispenser - Georgia Pacific enMotion Operating And Installation Instructions

LOADING REPLACEMENT ROLLS

(see illustration steps A-E)
A. A replacement roll can be added when the partial roll is
less than the width of the support (4" or less),
B. Pull the carousel lock bar toward you and rotate the
carousel down 180° until it locks.The partial roll should
now be on the bottom. Rewind excess towel back onto
the roll.
C. Place new roll in roll supports (make sure that the towel
is fed over the top).
D. Lift the tucker bar and tuck the towel behind it.
E. Fold and crease a 1" flap at the end of the towel by
folding it up. The tucker bar will be raised and will
activate/feed the new roll just before the old roll is
depleted.
If you are experiencing any problems with this
dispenser, call: 1-866-HELLO GP (435-5647).
STEP SEVEN

Troubleshooting the Dispenser

Dispense towels by moving hand in front of dispenser
within sensor range and immediately tear off towel. Repeat
this procedure 1-2 times to confirm proper operation. If
towel does not dispense when moving hand in front of
dispenser, open the dispenser and check the following:
1. Check inside the paper chute for a paper jam.
If necessary, clear.
2. Check that towel is properly loaded.
3. Advance towel using paper feed button to confirm
power.
4. If no power, check batteries to confirm alignment.
5. Close dispenser cover. Red light will turn off.The
dispenser is ready.
6. If a transfer does not occur, the dispenser will activate
once and default into a "Suspend" mode until paper is
properly loaded.The "Suspend"mode prevents
unnecessary battery drain and excess motor wear.To
reactivate the dispenser, re-load the replacement roll per
the loading instructions. enMotion
operation.
If light stays on or dispenser does not operate,
please call: 1-866-HELLO GP (435-5647).
ENGLISH
will continue normal
®