Advertisement
Installing and Removing the Cisco SM-X-1T3/E3 on Cisco 4451-X Integrated Services Routers
Removing the Cisco SM-X-1T3/E3 from a Cisco ISR 4451-X Router
Use the following procedure to remove the Cisco SM-X-1T3/E3 from a Cisco ISR 4451-X Router:
Read the
Step 1
Locate the service module (SM) to be removed.
Step 2
Using a number 1 Phillips or flat-blade screwdriver, unscrew the captive mounting screws on the module
Step 3
faceplate. See
Pull the Cisco SM-X-1T3/E3 out of the chassis.
Step 4
Place the SM in an antistatic bag to protect it from electrostatic discharge (ESD) damage.
Step 5
Installing the Cisco SM-X-1T3/E3 in a Cisco ISR 4451-X Router
Use the following procedure to install the Cisco SM-X-1T3/E3 on a Cisco ISR 4451-X Router:
Read the
Step 1
Remove the blank faceplates installed over the slot you intend to use.
Step 2
Push the Cisco SM-X-1T3/E3 into place until you feel the edge connector seat securely into the
Step 3
connector on the router backplane. The module faceplate should contact the chassis rear panel.
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module
Step 4
faceplate. See
Verifying Cisco SM-X-1T3/E3 Installation in a Cisco ISR 4451-X Router
Use the show diag command to verify that the Cisco SM-X-1T3/E3 has been installed correctly. In the
following example, one service module is recognized by the system.
router#show diag ?
all
chassis
slot
subslot
Router#show diag subslot 2/0 eeprom detail
Connecting Cisco T3 and E3 Service Modules to the Network
6
"Safety Warnings" section on page -2
Figure
1.
"Safety Warnings" section on page -2
Figure
1.
All related information
Chassis related information
Slot location information for this command
Subslot location information for this command
Connecting Cisco T3 and E3 Service Modules to the Network
before you perform any module replacement.
before you perform any module replacement.
OL-27149-01
Hide quick links:
Advertisement
