Advertisement
19
Ready for wiring
22
Lift canopy allowing the 2 studs
to protrude through the canopy
and install knurled nuts as shown.
Tighten the knurled nuts securely.
25
Connect white wire from fan to white
wire from light fixture. Then plug
blue wire from fan to black wire from
light fixture.
28
Place glass on fitter.
20
Fan
white
fuses
black
orange
blue
Green
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Orange from fan to Orange from remote
marked Light/up. Blue from fan to blue from
remote marked down light. Black from fan to
Black from remote marked L. White from
house to white from remote marked AC N .
Black from house to Black from remote
marked AC L. Connect all green ground wires
to Ground wire from House.
23
Remove the finial cap,finial nut
hex-nut and rubber washer from
the fitter.
26
Place the light fitter and tighten with
screws and washers.
29
Place hex-nut and rubber washer on
fitter, tighten securely, and then
place the finial cap over the threaded
rod and tighten the finial nut securely
by hand.
21
House
white
black
Make wire connections to power source using wire nuts
provided. Make sure that no filiments are outside of
the wirenut. After making the wire connections, the
wires should be spread apart with the grounded con-
ductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on
the other side of the outlet box. The splices after being
made should be turned upward and pushed carefully
up into the outlet box.
24
Remove three screws and wash-
ers from light fitter.
27
Install 3 x 40 watt candelabra base
bulbs. Bulbs not included.
30
Reverse function for this fan is a
switch on the top housing of the fan
body. Turn fan off and wait for fan to
stop then flip the switch to reverse
the direction of the blades.
Advertisement
