Horizon Fitness Andes 3 Service Manual page 10

CHAPTER IV
If output is DC 6V, the MCB motor defective. Replace ECB motor.
B) If the ECB motor can move, the resistance can be adjusted. If the resistance is still much
too heavier. Check the gap between orange block and the bottom. It shall be within 1-2
mm.
If the gap is bigger than 1-2 mm, the resistance will be heavier than normal. Adjust the cable
to the correct gap range.
4 If all above conditions are ok, and the resistance is still much heavier, inside magnet is
defective. Replace the inside magnet as the last step.
TROUBLESHOOTING