Toshiba TOSVERT VF-PS1 Instruction Manual page 16

Title
fh
Maximum frequency
RP/hign speed pulse input point
f234
1 setting
RP/hign speed pulse input point
f235
1 frequency
RP/hign speed pulse input point
f236
2 setting
RP/hign speed pulse input point
f237
2 frequency
f375
Number of PG input pulses
Selection of number of PG input
f376
phase
f377
PG disconnection detection
Note) In case of using shaft built-in type PG, set the RP/hign speed pulse input point 2 to a multiple
number of "1/ (a half number of motor poles)".
For example, set f236=50(%) in case of using shaft built-in type PG with 4-poles motor.
c) Previous check
You can check frequency reference from pulse input by monitor function previously.
Set the monitor selection to 1: frequency command.
See the section 8 of inverter instruction manual for the detail of monitor function.
Function
30.0～500.0
0 ~ 100
0.0 ~ fh
0 ~ 100
0.0 ~ fh
12 ~ 9999
1: Single-phase input
2: Two-phase input
3: Two-phase input (Inversion of
1: Disabled
2: Enabled (with filter)
3: Enabled (Detection of
15
Adjustment range
polarity)
momentary power failure)
E6581329①
Setting
(Example)
60.0（Hz）
0(%)
0.0(Hz)
100 (%)
60.0(Hz)
500
1
1