Fuji Electric ALPHA5 Smart User Manual page 626

CHAPTER 15 APPENDIXES
 GYG motor
The table below shows the cables and the connectors for the GYG motor and the servo amplifier.
Motor power cable
(1)
Motor power connector
(2) Power supply connector
(3) Sequence I/O cable
(4) Encoder cable
(6) DC circuit connector
□□: cable length
 Cable processing
(1) Motor power cable
Cut the amplifier-side connector part or the crimping terminal of the motor power cable, and then
connect it to the motor power connector for ALPHA5 Smart.
(2) Power supply cable
Cut the connector part of the power supply cable for FALDIC-W, and then connect it to the power
supply connector for ALPHA5 Smart.
15
(3) Sequence I/O cable
If the wiring of pulse is used with an open collector, be sure to cut the no. 7 pin (CA) and no.20 pin (CB)
on the amplifier-side connector.
15-34
Replacement (from FALDIC-W)
Purchase the connector for the
Supplied with the amplifier.
servo amplifier (Frame2,3)
Cut here.
Connection with a GYG motor
Purchase
Existing item can be used.
To be purchased.
To be purchased.
Existing item can be used.
amplifier side only.
Cut here.
Type
-
WSK-M03P-F
WSK-S03P-F
-
WSK-P06P-M
WSK-R05P-F