Commissioning, Inspection, Maintenance; Steps - Commissioning, Inspection And Maintenance - Viessmann Vitoflame 100 Service Instructions Manual

Steps - commissioning, inspection and maintenance

For further information regarding the individual steps, see the page indicated
•
• • •
• •
• •
•
• •
• •
• •
• •
•
• •
• •
•
• •
•
•
•
• •
• •
•
•
Commissioning steps
Inspection steps
Maintenance steps
1. Starting the heating system...........................................
2. Checking the adjustment of the air damper
servomotor......................................................................
3. Adjusting the oil pressure and checking the vacuum
4. Adjusting the air volume................................................ 10
5. Checking the 0-point setting of the blast tube
connection....................................................................... 11
6. Fully checking the burner
7. Cleaning and testing the flame monitor....................... 13
8. Shutting down the system
9. Checking electrical connections for firm seating
10. Cleaning the burner........................................................ 14
11. Checking the impeller fixings
12. Checking the flame tube fixings
13. Replacing the nozzle...................................................... 15
14. Checking and adjusting the ignition electrodes.......... 16
15. Installing the burner cover on the burner casing
16. Cleaning or, if required, replacing the oil pump filter. 18
17. Replacing pre-filter elements
18. Starting the system
19. Checking the oil lines and connections for leaks
20. Checking the burner again and entering the actual
values into the report
21. Operating and service documents................................ 19

Commissioning, inspection, maintenance

Page
6
7
7
5