Cisco 7940G Administration Manual page 16

Configuring the SIP Parameters Manually
To set a required parameter, select it and set it as desired. The following are required parameters that you
must set now if you did not set them in the default configuration file as described in the
Customize the Default Configuration File" section on page
line1_name—Number or e-mail address for use when registering. Enter a number without dashes.
•
For example, enter 555-0100 as 5550100. Enter an e-mail ID without the host name.
proxy1_address—IP address of the SIP proxy server that is used by the phones. Enter the address in
•
IP dotted-decimal notation or use the FQDN. The "x" argument is representative of server addresses.
If the parameter is provisioned with an FQDN, the phone sends REGISTER and INVITE messages
by using the FQDN in the Req-URI, To, and From fields.
proxy1_port—Port number of the SIP proxy server that is used by line 1.
•
If the proxy server with which the phone communicates has authentication enabled, set the following
•
parameters as well:
–
–
Step 4 Set additional parameters as needed.
To set a parameter, select it and set it as desired. Phone-specific parameters are listed in
Select Save.
Step 5
The phone programs the new information into flash memory and resets.
To restore parameters to default values, follow these steps:
Procedure
Unlock the phone.
Step 1
See the
Select Settings > SIP Configuration.
Step 2
The SIP Configuration menu appears.
Highlight the parameter whose setting you want to restore
Step 3
Step 4 Select Edit followed by <--.
Step 5 Select Accept.
Step 6 If necessary, select Back to exit the menu.
Cisco Unified IP Phone 7960G and 7940G Administration Guide for Release 8.0 (SIP)
3-16
line1_authname—Name used by the phone for authentication if a registration is challenged by
the proxy server during initialization. Default is UNPROVISIONED.
line1_password—Password used by the phone for authentication if a registration is challenged
by the proxy server during initialization. Default is UNPROVISIONED.
"Unlocking the Phone" section on page
Chapter 3 Initializing Cisco Unified IP Phones
3-4:
3-10.
"How to
Table 3-3.
OL-7890-01