Advertisement
Touch panel UP 588
Touch panel UP 588/11
Touch panel UP 588/21
Accessories: Design frame, anodised aluminium
Once the all-purpose cover has been removed, the de-
sign frame can be detached and fully dismantled by
loosening the fixing screw B5.
Disconnecting the power supply terminal (Diagram 3
"B")
To disconnect the power supply terminal C4, it must
-
first be pulled downwards out of the terminal com-
partment A1 via the latching mechanism A5. This can
be made easier by lifting the power supply terminal
C4 slightly using a narrow slotted screwdriver. It is in-
serted in the centre of the latching mechanism A5 be-
tween the power supply terminal C4 and the base of
the terminal compartment.
Removing the bus terminal (Diagram "A")
The bus terminal (C3) is located in the left terminal
-
compartment. It consists of two sections (C3.2 and
C3.3), each with four terminal contacts. Care should
be taken not to damage the two test sockets (C3.1)
either by accidentally connecting them to the bus
conductor or with the screwdriver [when trying to
remove the bus terminal].
Carefully insert the screwdriver in the wire entry slot
-
of the grey section of the bus terminal (C3.3) and pull
the bus terminal (C3) out of the built-in device. When
the red section of the bus terminal is removed, the
grey section remains connected.
Caution:
Do not remove the bus terminal from
underneath! There is a risk of shorting the
device!
Disconnecting the bus terminal (Diagram 3 "A")
Remove the bus terminal (C3) and the conductor (C3.4)
of the bus cable by rotating them simultaneously back-
wards and forwards.
Siemens AG
Automation and Drives Group
Electrical Installation Technology
P.O.Box 10 09 53, D-93009 Regensburg
D1
Subject to change without prior notice
Care instructions
The design frame and the plastic surface of the display
unit can be cleaning using conventional, solvent-free
cleaning materials. The surface of the display itself may
only be cleaned with a damp, soft cloth (e.g. cloth used
for cleaning a pair of glasses) and if necessary a mild
cleaning agent that is suitable for use on glass.
Dimension Diagram
Dimensions in mm
General Notes
• Any faulty devices should be returned to the local
Siemens office.
• If you have further questions about the product,
please contact our Technical Support:
+49 (0) 180 50 50-222
℡
+49 (0) 180 50 50-223
"
www.siemens.de/automation/support-request
h
UP 588, 6 pages
© Siemens AG 2006
Technical Product Information
5WG1 588-2AB01
5WG1 588-2AB11
5WG1 588-2AB21
5WG1 588-8AB01
190
Update: http://www.siemens.de/gamma
instabus EIB
April 2006
58
52
Technical Manual
2.3.1.4/5
Advertisement
