Olympus E-3 User Manual page 59

Hide thumbs Also See for E-3:

Table of Contents

The Super Control Panel Display for Wireless Flash Setup

POWER USER TIP: If working with numerous flashes in different

groups, it has been proven useful to make a sketch of the groups in

block format on a note pad and to number the flashguns with visible

numbers stuck to the rear-facing surface of the flash (Just do not cover

the red filtered area as this is the receiver/transmitter region). You can

then note the output level allocated to each flash unit on the plan which

makes changing settings on the remote display panel less of a guessing

game. The channel to be used for communication with the camera must

also be noted when set on the remote flash units as there are three

possible channels that can be used, All flash units in all groups and the

camera must be set to the same channel.

If using TTL or AUTO, you will note that the adjacent level block

will display the +/- 0.0 value. You can move the highlight block

to the right after pressing OK to confirm your operational mode

and now you can use the input dial to adjust this group's output

up or down by up to 5 EV values.

Table of Contents