Table of Contents
Advertisement
4
Installation
4.1
Tools list
The tools required to prepare the system for installation are:
▪
▪
▪
4.2
Preparing the EVC loudspeakers for installation
4.2.1
Unpacking and inspection
Carefully open the packaging and take out the loudspeaker. Inspect the loudspeaker's
enclosure for any damage that might have happened during transportation. Each loudspeaker
is examined and tested in detail before leaving the manufacturing site. Please inform the
transport company immediately if the loudspeaker shows any damage. Being the addressee,
you are the only person who can claim damages in transit. Keep the cardboard box and all
packaging materials for inspection by the transport company.
Keeping the cardboard box including all packing materials is also recommended, even if the
loudspeaker shows no external damage.
When shipping the loudspeaker, make sure to always use its original box and packaging
materials. By packing the loudspeaker exactly as it was packed by the manufacturer, you will
guarantee optimum protection from transport damage.
4.2.2
Scope of delivery
Keep the original invoice that states the purchase/delivery date in a safe place.
4.2.3
Recommended pre-installation procedures
For any sound system, certain checks made at the installer's place of business can prevent
expensive on-site delays. EV recommends that you take the following steps:
1.
2.
3.
4.
Once you are on site and the loudspeakers are connected, it is a good idea to check again for
continuity at the power-amplifier end of each cable run.
Electro-Voice
3/16-inch (5 mm) flat blade screwdriver
6 mm Allen wrench
Phillips #2 screwdriver
Unpack all loudspeakers in the shop.
Check for proper model numbers.
Check the overall condition of the loudspeakers.
Check for continuity at the loudspeaker inputs.
Installation manual
en
9
2018.01 | 01 | F.01U.345.997
Advertisement
Table of Contents
