Table of Contents
Advertisement
1.4 Technical Data
Packaging
Interface
Inputs
Outputs
Display
VME master modes
System Controller
Firmware
Performance
1.5 Power Consumption
Voltage
+5 V
1.6 Slave Module Base Address Jumper Settings
The VM-USB module can be used as a VME slave in A32, A24 or A16 mode. For this
purpose the base address BADR can be selected via 5 jumpers, which define bits 27-
31(A32), 20-24(A24) or 12-16 (A16) (always 5 most significant bits of the VME address).
By default the SLAVE Base Address is:
BADR = 0x08 0000 (A24).
BADR = 0x0800 0000 (A32).
WIENER, Plein & Baus GmbH
single wide 6U VME module
USB2 / USB1 auto-detecting / ranging, Connector: USB type B
2 user inputs, NIM level , LEMO
Multiplexed functionality (firmware 8504):
2 multiplexed outputs for VME, USB and DAQ signals, NIM
level, LEMO, function firmware dependent
4 programmable User LED's (green, red, green, yellow)
3 USB status LED's (USB1, USB2, Failure)
A16, A24, A32, D8, D16, D24, D32, BLT32, BLT16
bus arbiter and / or interrupt handler
Software upgradeable, 4 firmware locations
Selection via 8 position switch (P=program, C=use)
D32 via USB (EASY-VME): 128 kB/s
D32 with data buffering: 32 MB/s
BLT: 32 MB/s
Max. current
1.2 A
7
Power
about 8 W
www.wiener-d.com
Advertisement
Table of Contents
