Table of Contents
Advertisement
RUGGEDCOM RS401
Installation Guide
Figure 3: Panel Mounting
1. Screw 2. Panel/DIN Rail Adaptor
2.
Install the supplied screws to secure the adapters to the panel.
Section 2.2
Connecting Power
The RS401 supports a single integrated high AC/DC or low DC power supply
NOTE
• For 88-300 VDC rated equipment, an appropriately rated circuit breaker must be installed.
• For 100-240 VAC rated equipment, an appropriately rated circuit breaker must be installed.
• Use only #16 gage copper wiring when connecting terminal blocks.
• A circuit breaker is not required for 12, 24 or 48 VDC rated equipment.
• Power input terminals have reverse polarity protection for 12, 24 and 48 VDC rated equipment.
• Equipment must be installed according to applicable local wiring codes and standards.
CONTENTS
•
Section 2.2.1, "Connecting AC Power"
Connecting Power
1
Installing the Device
1
1
2
Chapter 2
7
Advertisement
Table of Contents
