Labelling Your Selcall Idents - GME TX3350 Instruction Manual

LEVEL
3. Press and hold the
The right-hand digit of the SelCall Ident will flash.
4. Press the or
in the flashing digit position.
5. Briefly press the
LEVEL
digit position.
6. Repeat steps 4 and 5 to enter all 5 digits as required.
7. Now press and hold the
flash for a few seconds then the radio will beep as the new
Ident is stored.
Recalling SelCall Idents from memory
1. Briefly press the CALL button.
with the last sent or received SelCall Ident.
2. Press the or
memory in locations 'C0' to 'C9'.
3. Press and hold the CALL button to send the Ident.
Changing your radio's own SelCall Ident
1. Ensure your radio is in Numeric Mode (press
as required until 'NUMER' is displayed).
2. Briefly press the CALL button.
with the last sent or received SelCall Ident.
3. Press the key. 'Id' will be displayed along with
your radios own SelCall Ident.
4. Press and hold the LEVEL
The right-hand digit of the SelCall Ident will flash.
5. Press the or
number in the flashing digit position.
LEVEL
6. Briefly press the
digit position.
7. Repeat steps 5 and 6 to enter all 5 digits as required.
8. Now press and hold the
flash for a few seconds then the radio will beep as the
new Ident is stored.
PA G E 1 6
key until the radio beeps.
keys to select the required number
key again to select the next
LEVEL
key. The entire Ident will
is displayed along
keys to select the required Ident
is displayed along
key until the radio beeps.
keys to select the required
key again to select the next
LEVEL key. The entire Ident will

LABELLING YOUR SELCALL IDENTS

You can label each SelCall Ident using a 5 character name
to make it easier to identify callers. If an incoming SelCall
matches one of those in your radio's memory, the label can be
displayed instead of the SelCall Ident.
To select the ALPHA display mode
Briefly press the
'ALPHA' or 'NUMER' will be displayed for 2 seconds on the
lower left of the display to indicate the selected mode.
TIP:
The normal channel display may give no indication of
which display mode is selected. The selected more will only
become obvious when displaying SelCall Idents.
Entering and storing a SelCall Label
NOTE:
You must first store the required Ident in memory (as
described above) before you can add an ALPHA label to it.
1. Briefly press the CALL button.
with the last sent or received SelCall Ident.
then
2. Press the
memory in locations 'C0' to 'C9'.
3. Briefly press
ALPHA will be displayed briefly.
4. If the selected memory's ALPHA label is empty, '- - - - -'
will be displayed, otherwise it will display the last ALPHA
label that was programmed into that memory.
5. Press and hold the
The left-hand position of the Alpha label will flash.
6. Press the
character in the flashing position then briefly press the
key again to select the next position.
LEVEL
7. Repeat step 6 to enter up to 5 characters as required.
8. Now press and hold the
will flash for a few seconds then the radio will beep as the
label is stored.
I N S T R U C T I O N M A N U A L
key followed by the
will be displayed along
or keys to select the required Ident
then to select the ALPHA mode.
LEVEL
key until the radio beeps.
or keys to select the required
LEVEL key. The entire Alpha label
key.
T X 3 3 5 0