Call Acknowledge; Storing Selcall Idents; Recalling Selcall Idents From The Memory; Naming Your Selcall Idents - GME TX6200 Instruction Manual

NOTE: Before continuing, ensure the radio is
in the Ident mode. Idents cannot be entered if
the radio is in Alpha mode. To toggle between
Alpha mode and Ident mode, briefly press
the Monitor key. A high beep indicates Alpha
mode is selected while a low beep means the
Ident mode is selected.
2. Enter the required Selcall Ident
as follows:
(a) Briefly press the F key. The right-
hand digit of the Selcall Ident will
flash.
(b) Press the
select the required number in the
flashing digit position.
(c) Briefly press the F key again to
select the next digit position.
(d) Repeat steps (b) and (c) to enter
all 5 digits as required.
3. Now press and hold the CALL key to
send the Ident.

CALL ACKNOWLEDGE

If your Selcall transmission is successful,
the radio you called should respond with
a 'call acknowledge' signal – usually two
quick beeps. This will confirm to you that
the radio you called is now alerting its
user to your signal.

STORING SELCALL IDENTS

Your TX6200 is fitted with 10 user
programmable Selcall Ident memories,
allowing you to store up to 10 frequently
used Selcall Idents. The memories are
accessed by pressing the CALL key then
pressing the or
memories are labelled c0 to c9.
To Store a Selcall Ident in memory
1. Press the CALL key to select the 'CALL
TO' mode. 'CALL TO' is displayed
along with the last sent or received
Selcall Ident.
2. Press the or
select the Ident memory that you wish
to programme (locations c0 to c9).
TX6200
or channel keys to
channel keys. Ident
channel keys to
I N S T R U C T I O N M A N U A L
TIP: If the radio displays letters instead of
numbers in the Selcall Ident position, your
radio is in ALPHA mode. To switch back to
Ident mode, briefly press the Monitor key. A
low beep should be heard indicating Ident
mode is now selected.
3. With the required memory location
displayed, enter the Selcall ident as
follows:
(a) Briefly press the F key. The right-
hand digit of the Selcall Ident will
flash.
(b) Press the
select the required number in the
flashing digit position.
(c) Briefly press the F key again to
select the next digit position.
(d) Repeat steps (b) and (c) to enter
all 5 digits as required.
(e) Now press and hold the F key. The
entire Ident will flash for a few
seconds then the radio will beep
as the new Ident is stored.
RECALLING SELCALL IDENTS
FROM THE MEMORY
1. Press the CALL key to select the 'CALL
TO' mode. 'CALL TO' is displayed
along with the last sent or received
Selcall Ident.
2. Press the or
select the Ident memory that you wish
to recall (locations c0 to c9).
3. When the required Selcall memory is
displayed, press and hold the CALL
key to send the Ident.
NAMING YOUR SELCALL
IDENTS
The TX6200 allows you to name each
Selcall Ident using a 5 character ALPHA
name. The name is stored in memory
along with the Ident making it easier to
identify whose Ident you are recalling
from the memory. If an incoming Selcall
matches one of those in your radio's
or channel key to
channel keys to
PAGE 17