Electrolux EXP09CKEWI User Manual page 15

1. Press the "mode" button until the Fan
mode indicator is lit�
2. Press the "Fan speed" button to choose
the desired fan speed�
3. The fan will run at the selected speed
and the display will show the room
temperature�
Auto mode
Always have the exhaust hose attached in
this mode�
When you set the air conditioner in Auto
mode, it will automatically select cooling,
heating (inapplicable for cooling only
models), or fan only operation depending
on what temperature you have selected
and the room temperature� The air
conditioner will control room temperature
automatically round the temperature point
set by you�
Under AUTO mode, you can not select the
fan speed�
1� Press the "mode" button until the "Auto
mode" indicator lights�
After the "Auto mode" is selected the unit
will run automatically according to the
actual room air temperature�
Timer mode
The timer facilitates the user to delay the
unit startup or shutdown�
How to delay startup
Plug in the unit, so the unit turns to
standby�
Press the "timer" button, then the Timer
indicator and number of hours on the
screen will flash�
Tap or hold the UP arrow "
DOWN arrow " " to change delay start
timer at 0�5 hour increments up to 10
hours, then at 1 hour increments up to 24
hours�
After 5 seconds, the Timer indicator and
the display stop flashing� The control
will count down the time remaining until
startup�
The unit will start up in the mode as
previously set�
To cancel the setting, press the "timer"
button again� The timer indicator will
switch off�
How to delay shutdown
You can delay shutdown when the unit is
on�
Press the "timer" button, then the Timer
indicator and number of hours on the
screen will flash�
Tap or hold the UP arrow "
DOWN arrow "
timer at 0�5 hour increments up to 10
hours, then at 1 hour increments up to 24
hours�
After 5 seconds, the Timer indicator and
the display stop flashing, and the display
shows the time remaining until the unit
shuts down�
To cancel the setting, press the "timer"
button again� The timer indicator will
switch off�
Filter reset
This feature is a reminder to clean the Air
Filter (See Care and Cleaning) for more
efficient operation�
The filter indicator will illuminate after 250
hours of operation� To reset after cleaning
the filter, hold the "fan speed" button for 5
seconds, then the "filter" indicator will go
" or the
off�
ENGLISH
" or the
" to change delay stop
15