Sharp FU-60SE-TA Service Manual page 25

5. How to remove the dust sensor and
display PWB
(1) Pry the dust sensor fixing claw and remove the
dust sensor.
Dust sensor fixing craw
Dust sensor
CAUTION
When assembling, pay attention to the attaching
direction of the dust sensor.
Attach it so that the lead wire goes to the slit side
of the front cabinet.
(2) Remove 3 indication PWB fixing screws (M4 x
10 pan head) and lift it.
Display PWB fixing screws
(3) Remove the dust sensor harness connector,
LED support (it is fixed with 2 claws positioned
right and left) and the sensor switch knob.
(When the LED guide is removed, the Light lead
guide can be removed.)
Dust sensor
harnnes connector
Slit
LED guide
Sensor switch knob
25
6. How to remove the power PWB
(1) Remove 2 Top PWB box fixing screws
(M4 x 14 binding head).
Control box fixing screws
Top PWB box
(2) Remove the power supply connector, High
voltage harness connector, motor wire
connector.
High voltage harnnes connector
Motor wire connector
FU-60SE-TA
Power supply connector