Makita GA7060 Instruction Manual page 11

Operation with abrasive cut-off /
diamond wheel
Optional accessory
WARNING:
When using an abrasive cut-off
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
WARNING:
NEVER use cut-off wheel for side
grinding.
WARNING:
Do not "jam" the wheel or apply
excessive pressure. Do not attempt to make an
excessive depth of cut. Overstressing the wheel
of kickback, wheel breakage and overheating of the
WARNING:
Do not start the cutting operation
in the workpiece. Let the wheel reach full speed
and carefully enter into the cut moving the tool
forward over the workpiece surface. The wheel
started in the workpiece.
WARNING:
During cutting operations, never
change the angle of the wheel.
the wheel to crack and break, causing serious per-
WARNING:
A diamond wheel shall be oper-
ated perpendicular to the material being cut.
lock nut onto the spindle.
1
2
3
1. Lock nut 2. Abrasive cut-off wheel / diamond
wheel 3.
cut-off wheel / diamond wheel
4
4. Wheel guard for abrasive
For Australia and New Zealand
1. Lock nut 2.
wheel / diamond wheel 4.
guard for abrasive cut-off wheel / diamond wheel
Operation with wire cup brush
-
Optional accessory
CAUTION:
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
or which is out of balance. Use of damaged brush
broken brush wires.
1. Wire cup brush
access to spindle.
brush onto spindle and tighten with supplied wrench.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush.
11 ENGLISH
ø45
1
ø78
2
3
ø78
4
3. Abrasive cut-off
Check operation of brush by run-
Do not use brush that is damaged,
5
5. Wheel
1