How To Use Flash Power Control - Sekonic LITEMASTER PRO L-478DR-A-EL Operating Manual

2-2-2. How to use Flash Power Control

1) Touch the Measuring mode icon at the top left of the
Measuring screen and then select the Radio Flash Mode
( ).
2) Touch the Flash Power Control icon (
screen to display the Flash Power Control screen.
3) Select one of Groups (G1 to G4)
Measuring button to trigger the flash units for selected
Group.
4) The measured value is displayed at the top of the screen
and over the selected Group button
1
button to change the power of flash. Set power level is
4
displayed in the area of
* Up to +/-9.9 step of value (f stop) can be controlled.
* Set power level returns to 0 (zero) when taking a new measurement,
selecting another Group or turning the power off/on.
5) Press the Measuring button for measurement to confirm
that the flash power is set to desired value.
6) Repeat 3) to 5) above for other Groups
unit's brightness is set to proper value for the effect you
want.
7) Select [ALL] button and press the Measuring button.
Measured values of each Group
measured F number for the measured brightness of all lights
will be displayed at the top of the screen
8) Press [+] or [-] button
units while each Group lighting ratio is kept.
* Press Modeling Lamp ON/OFF icon (
desired Group.
* To set ISO sensitivity and shutter speed, press the Radio Flash Mode
icon ( ) to go back to the Measuring screen.
) on the Measuring
and press the
3
2
.
5
3
will not change. The
2
to change the total power of flash
4
) if necessary after selecting the
7
. Press [+] or [-]
until each flash
.
1
Measuring screen
Flash Power Control screen
1
2
3
4
Settings
(EL-Skyport mode, FCH,
shutter speed and ISO
sensitivity)
Flash Power Control
screen (After Measurement)
5