Auxiliary Dc Jack; Auxiliary Dc Connector - Yamaha MWS150-C Owner's Manual

Auxiliary DC jack

WARNING
To prevent electrical shock or short-
circuiting, make sure that the cap is
installed when the auxiliary DC jack
is not being used.
NOTICE
The accessory connected to the
auxiliary DC jack should not be used
with the engine turned off, and the
load must never exceed 12 W (1 A),
otherwise the fuse may blow or the
battery may discharge.
This vehicle is equipped with an auxil-
iary DC jack in the accessory box.
A 12-V accessory connected to the
auxiliary DC jack can be used when the
key is in the "ON" position and should
only be used when the engine is run-
ning.
To use the auxiliary DC jack
1. Open the accessory box lid. (See
page 4-18.)
2. Turn the key to "OFF".
EAU39657 3. Remove the auxiliary DC jack cap.
EWA14361
ECA15432
1. Auxiliary DC jack cap
4. Turn the accessory off.
5. Insert the accessory plug into the
auxiliary DC jack.
1. Auxiliary DC jack
6. Turn the key to "ON", and then
start the engine. (See page 6-1.)
7. Turn the accessory on.
Instrument and control functions

Auxiliary DC connector

This vehicle is equipped with an auxil-
iary DC connector. Consult your
1
Yamaha dealer before installing any
accessories.
1
4-22
EAU70641
4