Yamaha MWS150-C Owner's Manual page 28

Instrument and control functions
Fuel reserve tripmeter
4
1. Fuel reserve tripmeter
When approximately 1.6 L (0.42 US
gal, 0.35 Imp.gal) of fuel remains in the
fuel tank, the last segment of the fuel
meter and the fuel level warning indica-
tor will start flashing. The display will
automatically change to the fuel re-
serve tripmeter and start counting the
distance traveled from that point. In
this case, push the "SELECT" button
to switch the display in the following
order:
F → TRIP 1 → TRIP 2 → OIL TRIP →
BELT TRIP → ODO → F
To temporarily turn off the fuel reserve
tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RE-
SET" button for one second. To turn
the fuel reserve tripmeter back on, turn
the key to "OFF" and then to "ON". The
fuel reserve tripmeter will be displayed
again after one minute.
The fuel reserve tripmeter will reset au-
tomatically and disappear after refuel-
ing and traveling 5 km (3 mi).
1
Oil change tripmeter "OIL TRIP"
1
1. Oil change indicator "OIL CHANGE"
2. Oil change tripmeter
The oil change tripmeter shows the
distance traveled since the oil was last
changed.
The oil change
CHANGE" will come on at the initial
1000 km (600 mi), then at 4000 km
4-9
(2500 mi), and then every 4000 km
(2500 mi) thereafter to indicate that the
engine oil should be changed.
After changing the engine oil, reset the
oil change indicator and the oil change
tripmeter. To reset them both, select
the oil change tripmeter, and then push
the "RESET" button for one second.
While "OIL CHANGE" is flashing, push
the "RESET" button for three to four
2
seconds. The oil change tripmeter will
be reset and the oil change indicator
will turn off.
TIP
If the engine oil is changed before the
oil change indicator comes on (i.e., be-
fore the periodic oil change interval has
been reached), the oil change tripmeter
must be reset for the oil change indica-
tor to come on at the correct time.
indicator "OIL