Handlebar Switches - Yamaha MWS150-C Owner's Manual

V-belt replacement tripmeter "BELT
TRIP"
1
1. V-belt replacement indicator "V-BELT"
2. V-belt replacement tripmeter
The V-belt replacement
shows the distance traveled since the
V-belt was last replaced.
The V-belt replacement indicator "V-
BELT" will come on every 20000 km
(12500 mi) to indicate that the V-belt
should be replaced.
If the V-belt replacement indicator has
come on, after replacing the V-belt, re-
set the V-belt replacement indicator
and the V-belt replacement tripmeter.
To reset them both, select the V-belt
replacement tripmeter, and then push
the "RESET" button for one second.
While "V-BELT" is flashing, push the
"RESET" button for three to four sec-
onds. The V-belt replacement tripme-
ter will be reset and the V-belt
2
replacement indicator will turn off.
TIP
If the V-belt is replaced before the V-
belt replacement indicator comes on
(i.e., before the periodic V-belt replace-
ment interval has been reached), the V-
belt replacement tripmeter must be re-
set for the V-belt replacement indicator
to come on at the correct time.
tripmeter
Instrument and control functions

Handlebar switches

Left
1. Dimmer switch "
2. Turn signal switch "
3. Horn switch "
Right
1. Start switch "
4-10
EAU1234K
1
2
3
/ "
/ "
"
1
"
4