Yamaha MWS150-C Owner's Manual page 65

Cleaning the V-belt case check hose
1
1. V-belt case check hose
1. Check the hose on the rear side of
the V-belt case for accumulated
dirt or water.
2. If dirt or water is visible, remove
the hose from the clamp, clean it,
and then install it.
TIP
If dirt or water was found in the check
hose, be sure to check the V-belt case
air filter element for excessive dirt or
damage and clean or replace it if nec-
essary.
Periodic maintenance and adjustment
Cleaning the V-belt case air filter el-
ement
1. Place the vehicle on the center-
stand.
2. Remove the screws, and then pull
the V-belt case air filter element
cover outward and away from the
V-belt case.
2
2
1. V-belt case air filter element cover
2. Screw
3. Pull the V-belt case air filter ele-
ment out, and then clean it with
solvent. After cleaning, remove
the remaining solvent by squeez-
ing the element. WARNING! Use
only a dedicated parts cleaning
solvent. To avoid the risk of fire
or explosion, do not use gaso-
line or solvents with a low flash
7-18
point.
[EWA10432]
damaging the air filter element,
handle it gently and carefully,
and do not twist it.
1
1. V-belt case air filter element
4. Apply oil of the recommended
type to the entire surface of the
sponge
squeeze the excess oil out.
NOTICE: To avoid
[ECA10522]
1
material, and then
7