Removal steps of the front-facing camera module and front-facing-camera-module cable
Notes:
• Do not close the connector flips before inserting the cable.
• When installing the cable, ensure that the connectors are attached firmly.
Step
Screw (quantity)
3
M1.6 × 3.5 mm, flat-head, nylon-coated (1)
1110 Wireless WAN card
The wireless wide area network (WAN) card is only available on some models.
Before you start, do the following:
1. Follow the instructions in "Before servicing the tablet" on page 46.
2. For access, remove the back cover assembly. See "1010 Back cover assembly" on page 48.
3. Remove the connector of the built-in battery from the system board. See step 1 in "1050 Built-in
battery" on page 54.
Removal steps of the wireless WAN card
Unplug the connectors by using the antenna radio frequency (RF) connector removal tool or gently pick up
the connectors with your fingers.
1
Torque
Color
Black
0.098 Nm
(1.00 kgf-cm)
.
Chapter 7
Removing or replacing a FRU
59