Table of Contents
Advertisement
The SMA cable should be connected to Wavecom module.
Figure 5.5 Wavecom UFL/SMA connector
When installing the module into the base board, please make sure the module is con-
nected with system connector and the ground pin is inserted into the four holes as
marked below in red. It is highly recommended to solder the four ground pins.
Figure 5.6 Mounting wavecom on AMO base board
Plug AMO-EDGE bottom CN3 into the ARK-1388V CN23 and attach with a screw
M2.5*5L from the package. This finishes the installation of AMO-EDGE. Then com-
plete reassembly.
ARK-1388V User Manual
54
Advertisement
Table of Contents
