To Cancel An Alarm; To Reset After An Alarm - Texecom veritas excel User Manual

Veritas Excel User Guide

To CANCEL an Alarm

The display will look something like this:
Enter your 4-digit Access code
sounders will stop but the external strobe will continue to flash.
! "
If you were not present when the alarm activated, the internal and external
sounders will have already stopped after a pre-programmed time. The
system will re-arm but the external strobe will continue to flash.

To RESET After an Alarm

The display will look something like this:
>?33%@$*%
63/.=0::::::CDK:%
! "
The number of the zone that caused the alarm will be flashing (in this case
Zone 6) and the numbers of all subsequent zones violated (if any) will be
on (in this case Zones 7 & 8).
To display the descriptive text associated with a particular zone number,
press and hold the corresponding key
Press to acknowledge the alarm, the external strobe will stop, the system
, , , ,
will chime and the display will return to normal.
! "
If the system has been programmed to be reset by an engineer, pressing
will not return the display to normal. If this is the case contact your
,
alarm company.
The system may have been programmed to be reset by Anti-Code, if this is
the case, see page 8 for details.
INS166
B3$/0$%1#*$.%
F"?.%B/00+"<$%
#### ####
#### ####
% >?33%@$*%
63/.=0:::::::DK:%
, the internal and external
.
# #
# #
Using Your Alarm
7