To Unset The Alarm; To Omit Zones When Setting - Texecom veritas excel User Manual

Using Your Alarm

To UNSET the Alarm

Enter via a designated entry route, the slow entry tone will start and the display
will read as follows:
Enter your 4-digit Access code
and the display will read as follows for 5 seconds before reverting to normal:
! "
During the last 10 seconds of the entry period the entry tone will change
from slow to fast.

To OMIT Zones When Setting

It is possible to exclude (omit) or include individual zones during setting.
Enter your 4-digit Access code
Set Suite number
timer will stop and the display will look something like this:
>?33%@$*%I%6.=%
!"#$0%58&JACDKLB%
! "
To display the descriptive text associated with a particular zone number,
press and hold the corresponding key
Press the number key(s)
Press * * to complete the omitting procedure, the system will revert back to
* *
the exit mode and the exit tone will restart.
! "
Only zones that have been programmed to be omittable by the Installer can
be omitted.
The system will automatically return to exit mode 16 seconds after the last
key is pressed.
If the system has a power fault i.e. a mains failure, this will be indicated by a
'P' on the display. The system can still be set by omitting zone number
6
B3$/0$%1#*$.%
F"?.%B/00+"<$%
#### ####
#### ####
@G0*$=%H#0$*%
45%67.%%58944:44%
#### ####
#### ####
and press
# #
# #
%
... of the zone(s) to be omitted or included.
# # # #
, the entry tone will stop
. Press
. Press
( ( ) )
( ( ) )
B/.*%@$*%8%I%6.=%
!"#$0%58&JEEEKLB%
.
# # # #
Veritas Excel User Guide
or enter Part
$ $
$ $
, the exit tone and exit
+
.
INS166