To Cancel The Exit Mode; To Clear An Arm Fail - Texecom PREMIER 24 Master User Manual

Operating the Alarm System

To CANCEL the Exit Mode

Once the exit mode has been started you should leave the premise immediately, however,
if for some reason you decide not to leave, the exit mode must be cancelled.
To cancel the exit mode, proceed as follows:

To CLEAR an Arm Fail

When the system tries to arm with zones active (open), the internal sounders will sound
and the external strobe will be flashing to indicate a problem. For details on preventing
an Arm Fail condition, please refer to page 10.
!"
If you were not present when the arm fail occurred or you do not clear the arm fail, the
internal sounders will continue to sound and the external strobe will continue to flash.
To clear the arm fail, proceed as follows:
The alarm will be sounding and the display will look something like this:
The internal and external sounders will stop, the external strobe will continue to flash and
the number of the zone that caused the arm fail will be displayed (in this case Zone 2).
Enter a valid User code
18
Enter a valid User code
K($6(=$9"13$3(
!"1/,#$0W.3E
Press
The exit tone will stop
$$
$<=,$>?$7"&$@>>A
The exit mode has now been cancelled.
%&,"$%47$*%\C$L
$$$$%)))))))
Enter a valid User code
%&,"$%47$*%\C$L
$$$$%)))))))
O(1,$>>@$%/3.-,
D,H&(('$M.1H(9
1111
$$
$<=,$>?$7"&$@>>A
The arm fail has now been cleared.
Premier Series User Guide
1111
#
1111
and press
)
INS177