Reference Data; Creating Pulse Hardware State And Instrument State Files - HP 8510 User Manual

Reference Data

Creating Pulse Hardware State and Instrument State Files

If the HP pulsed-RF system tape is not available, create the necessary les as follows.
1. Press to set the instrument to a known state.
4 PRESET 5
2. Set system bus HP-IB addresses of sources:
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
HP-IB ADDRESSES
4 SYSTEM 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNN
SOURCE #1 1
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN NNNNN
SOURCE #2 1
3. Set sweep mode.
Press
4 STIMULUS MENU 5
4. Multiple source control.
Edit the Multiple Source con guration to set the LO source 20 MHz above the test source
and tune the receiver to 20 MHz as follows:
NNNNNNNNNNNNNN
MORE
4 SYSTEM 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DEFINE SOURCE 1
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
OFFSET FREQUENCY
Network Analyzer
System Bus
8510
System Bus
Source #1
Test Set
Plotter
Printer
Disc
Source #2
PASS-THRU
RF Switch
NNNNN NNNNNNNN
9 x1
NNNNN NNNNNNNN .
8 x1
NNNNNNNNNNNNNN .
STEP
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
EDIT MULT. SRC.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MULTIPLIER NUMER
NNNNN NNNNNNNN NNNNNNNNNNNNNN
0 x1 DONE
HP-IB Addresses
16
17
19 (RF)
20
05
01
00
18 (LO)
31
31
NNNNNNNN NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
x1 MULTIPLIER DENOM.
11
NNNNNNNN
x1
Reference Data 11-1