Table of Contents
Advertisement
Page 4 of 12
GENERAL INFORMATION
Your Hayward SwimClear
corrosion-free construction. With filtration ratings to 9000 gallons (34 Kl) per hour, they are designed for continuous or
intermittent operation, for installation above or below the pool water line, for fresh or salt water swimming pools or spas.
SwimClear™ filters utilize multiple reusable, reinforced polyester filter cartridge elements to provide a high degree of
water clarity and long filter cycles with minimum care.
1.
The filter system should be installed, not more than 6 feet above pool water level, or below the pool water
level, on a level concrete slab, very firm ground, or equivalent. Select a well drained area, one that does not
flood when it rains. Position the filter so that the piping connections, control valve and winter drain are
convenient and accessible for operation, service and winterizing.
2.
Position filter so the tank can drain by gravity.
3.
If practical, place pump and filter in the shade to shield it from continuous, direct heat from the sun.
4.
Connect the pool suction plumbing between the skimmer, pool outlet and the pump.
5.
Install the pool return plumbing.
6.
If pressure gauge is not installed, apply Teflon tape to the gauge threads and carefully screw the gauge into the
gauge adapter assembly.
STARTING THE PUMP and FILTER SYSTEM
Before Starting the Pump
1. Verify the filter body clamp and spring nut assembly properly assembled, filter manual air relief body is in LOCK
position, and no filter components are missing, damaged or not genuine Hayward components.
2. Close filter drain.
3. Open all system valves to allow normal system operation.
4. Place the manual air relief valve in OPEN position.
Starting Pump
1. Stand at least 10 feet away from filter before starting pump. If water leakage appears at tank clamp, shut off system
pump before returning to filter to service leak.
2. Return to filter to close manual air relief valve only when a steady stream of water (not air or, air and water mix) is
discharged from the manual air relief valve.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
SWIMCLEAR CARTRIDGE FILTER
TM
cartridge filter combines superior water filtration with ease of operation and totally
A
IN
C2020
32.5
C3020
34.5
C4020
40.5
C5020
46.5
INSTALLATION
qualified professional.
Only simple tools (screwdriver and wrenches), plus pipe sealant for plastic adapters,
are required to install and/or service the filter.
WWW.HAYWARD.COM
REQUIRED CLEARANCE
"B" SIDE
CM
IN
CM
83
18
46
88
18
46
103
18
46
118
18
46
This product should be installed and serviced only by a
ISC2027 REV D
"C" ABOVE
IN
CM
15
38
16
41
18
46
22
56
Hide quick links:
Advertisement
Table of Contents
