Table of Contents
Advertisement
Cisco BTS 10200 Provisioning
International PRI Setup
This section describes how to provision the Cisco BTS 10200 Softswitch for International PRI.
International PRI uses the International Telecommunications Union (ITU)/European
Telecommunication Standards Institute (ETSI) standard.
Note
Configure PRI FAS.
Step 1
Figure 1-8
Figure 1-8
a.
b.
c.
d.
e.
Cisco BTS 10200 Softswitch ISDN Provisioning and Troubleshooting
1-14
ITU/ETSI uses a primary net-5 switch.
shows a sample configuration for Facility Associated Signaling (FAS).
Sample Configuration for FAS
Trunk group (100)
CIC start
Interface - 0
1
Add ISDN D-channel profile with the nfas-supp token set to N.
add isdn-dchan-profile ID=NI2; description=dallas isdn dchan profile no.1;
type=SWV-ETSI-PRI; interface-type=network; isdn-restart-pri-supp=Y;
isdn-restart-interface-supp=y;isdn-service-supp=n; isdn-restart-chan-supp=y;
isdn-farend-init=n;isdn-query-supp=n;nfas-supp=n; bchan-neg-supp=y; t-301=300;
t-302=10; t-303=4; t-305=30;t-308=4; t-309=90;t-310=10; t-316=30; t-321=20;t-322=4;
t-323=30;
See the
"ISDN Profiles" section on page 1-16
Note
Add the ISDN interfaces.
add isdn-intf isdn-dchan-id=100; INTF=0;
Add the ISDN D channels using the backhaul session set ID added in Step 2c in the
section on page 1-5
and the ISDN interfaces added in Step 1b.
add isdn-dchan id=100; backhaul-type=RUDP;set-id=backset1; DCHAN-SLOT=0;
DCHAN-PORT=1; DCHAN-TYPE=primary; DCHAN-INTF=0; isdn-dchan-profile-id=NI2;
Add an ISDN trunk group profile.
add isdn-tg-profile id=dallas1; chrg-num-supp=Y;
Add the ISDN trunk groups using the ISDN trunk group profile added in Step 1d.
add trunk-grp id=100; call-agent-id=CA146;tg-type=ISDN; tg-profile-id=ISDN1;
glare=all; mgcp-pkg-type=T; dial-plan-id=dp1; dial-plan-id=dp1; isdn-dchan-id=100;
For ISDN trunk groups, the mgcp-pkg-type token must be set to T.
Note
D Channel
CIC end
16
32
for more information.
Chapter 1
ISDN Provisioning
"Provisioning"
OL-12436-02
Advertisement
Table of Contents
