Table of Contents
Advertisement
The accessory kits covered in this instruction are
designed for use on specific models of Triumph
motorcycle. The accessory kits and the models
applicable are listed at the start of the instruction.
They should not be fitted to any other Triumph
model or to any other manufacturer's motorcycle.
Fitting an accessory kit to a Triumph model not
listed, or to any other manufacturer's motorcycle,
will affect the performance, stability and handling of
the motorcycle. This may result in loss of
motorcycle control and an accident.
Always have Triumph approved parts, accessories
and conversions fitted by a trained technician of an
authorised Triumph dealer. The fitment of parts,
accessories and conversions by a technician who is
not of an authorised Triumph dealer may affect the
handling,
stability
or
motorcycle's operation which may result in loss of
motorcycle control and an accident.
Throughout
this
operation,
motorcycle is stabilised and adequately supported
to prevent risk of injury from the motorcycle falling.
A torque wrench of known accurate calibration
must be used when fitting this accessory kit. Failure
to tighten any of the fasteners to the correct
torque
specification
performance, handling and stability. This may result
in loss of motorcycle control and an accident.
If the engine has recently been running, the
exhaust system will be hot. Before working on or
near the exhaust system, allow sufficient time for
the system to cool, as touching any part of a hot
exhaust could cause burn injuries.
Warning
Warning
other
aspects
of
Warning
ensure
that
Warning
may
affect
motorcycle
Warning
Note:
•
Ensure that a relevant Triumph Service Manual is
available for reference during the fitting of this
accessory kit.
•
For Tiger 800 and Tiger 800XC models up to
VIN 583614, a suitable hand-held power drill with
a 7 mm diameter drill bit and a 24 mm diameter
sheet metal punch are required to fit this kit.
•
Triumph offers a broad range of approved
genuine accessories for your motorcycle. We
cannot therefore cover all possible equipment
variations in these instructions. For removal and
installation of Triumph Genuine Accessories
always refer to the instructions supplied with the
respective accessory kit.
Installation of the Pannier Third Mounts and
Pannier Cable
1.
Position the motorcycle on a paddock stand.
2.
Remove the rider's seat, as described in the
the
Owner's Handbook.
Note:
•
For Tiger 800 and Tiger 800XC up to VIN 583614,
continue from step 3.
•
For Tiger 800, Tiger 800XC, Tiger 800 XR,
Tiger 800 XR
the
Tiger 800 XC
Tiger XR
T
Tiger XCx from VIN 583615 continue from
step 30.
•
Lock nuts can be reused, providing resistance
can be felt when the locking portion passes over
the thread of the bolt or stud.
•
Always use the correct replacement lock nut as
recommended in the Triumph parts catalogue.
4 of 20
, Tiger 800 XC
, Tiger 800 XR
X
X
, Tiger 800 XR
A
X
, Tiger XRx, Tiger XC, Tiger XC
,
T
LRH, Tiger XR,
and
A
Hide quick links:
Advertisement
Table of Contents
