EdgeStar AP14009COM-1 Owner's Manual page 18

Dehumidifying Mode
During the Dehumidifying mode, the unit will condense water out of the air and exhaust it through
the exhaust hose. The ambient temperature in the room will probably drop by a few degrees while
using the Dehumidifying mode. The front panel lights will illuminate yellow.
To operate the unit in dehumidifying mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button
3. Press the Mode button
Notes: If the room temperature is below 77° F, the fan will always run on low speed while in the
Dehumidifying mode. If you do not use the exhaust hose in Dehumidifying mode, you must
manually drain the water from the unit. Additionally, the ambient temperature in the room will
probably rise by a few degrees if you do not use the exhaust hose. You will not be able to change
the thermostat temperature while in Dehumidifying Mode.
Fan Only Mode
Fan Only mode is used to circulate the air in your room. No temperature setting is needed. The
front panel lights will illuminate green.
To operate the unit in Fan Only mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button
3. Press the Mode button
4. Press the Fan Speed button
Automatic
Automatic Mode
In Automatic mode, the unit will cool, dehumidify, or heat (some models) depending on the ambient
temperature. As the temperature in the room changes, the mode and fan speed will change
automatically. The front panel lights will change depending on the mode.
To operate the unit in Automatic mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button
3. Press the Mode button
15
on the remote control.
until the Dehumidify
on the remote control.
until the Fan Only indicator
, High , Medium
on the remote control.
until the Automatic indicator
indicator is selected.
to select the Fan Speed. You can choose between
, or Low .
is selected.
is selected.