FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This Equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from which the
•
receiver is connected to.
Consult the dealer or an experienced radio/TV technician for help.
•
Warning:
Use only shielded signal cables to connect I/O devices to this equipment. You are
cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Need help?
Do you have a question about the X5-MS and is the answer not in the manual?
Questions and answers
how to activate Magic Toudh in Cy'berview x
To activate Magic Touch in CyberView X5-MS, enable the "Magic Touch" function in the settings. This option can be toggled on or off to utilize the hardware-based technology for removing dust and scratches during the scanning process.
This answer is automatically generated