Generating Scenarios - Keysight M8190A User Manual

8 General Programming

8.21.4 Generating scenarios

8.21.5 [:SOURce]:STABle[1|2]:RESet
Command
Long
Parameters
Parameter Suffix
Description
Example
8.21.6 [:SOURce]:STABle[1|2]:DATA[?]
<sequence_table_index>,(<length>|<block>|<value>,<value>...)
Command
Long
Parameters
Parameter Suffix
260
Set the scenario advancement mode using the STAB[1|2]:SCEN:ADV command.
Set the scenario loop count using the STAB[1|2]:SCEN:COUN command.
Select the sequence table entry that describes the first segment in your scenario
using the STAB[1|2]:SCEN:SEL command.
Select non-dynamic mode using the command STAB[1|2]:DYN OFF.
Before starting signal generation with INIT:IMM[1|2] select the scenario mode
using the FUNC:MODE STSC command.
:STAB:RES
:STABle:RESet
None
None
Reset all sequence table entries to default values.
Command
:STAB:RES
:STAB:DATA[?]
:STABle:DATA[?]
<sequence_table_index>,(<length>|<block>|<value>,<value>...)
None
M8190A User's Guide