Fimco LG-4-3-1 Owner's Manual

General Information
Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden spot sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.
Warranty
Products are warranted for one year from date of purchase
against manufacturer or workmanship defects for home owner
usage and 90 days for commercial usage.
For technical assistance, visit our website @
www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027
Our Technical Support Representatives will be happy to help you.
To obtain prompt, efficient service, always remember to give the
following information...

Correct Part Description and/or part number

Model #/Serial # of your sprayer
Part descriptions and numbers can be obtained from the illustrated
parts list section(s) of this manual.
OWNER'S MANUAL
Model: LG-4-3-1 (5302314)
(4 Gallon, 3.6 V, Spot Sprayer)
Technical Specifications

4 Gallon Corrosion-Resistant Polyethylene Tank

Rechargeable Handgun

Continuous Use Over 1 Hour

2.5 Hours Recharge Time

Removable base for handheld spraying

Ergonomic Back Pack Straps for back pack spraying

6-3/4" Wheels with high ground clearance

Unit height with base = 39"

Tank height without base = 19"
NOTE:
It is VERY important for you to test your sprayer with plain
water before actual spraying is attempted.
Allow 20 seconds for the fluid to reach the handgun and begin
spraying. If the fluid does not reach the handgun and drains out of
the hose when the trigger is released, the hose is not connected
to the handgun correctly. Disconnect and reconnect the quick
connect shut off and begin priming again. If the fluid does not
reach the handgun and stays in the coiled hose, lower the hand-
gun below water level, this will allow the pump to prime.
Operation
Fill the tank 1/2 full with water first and then add the chemical slowly, mix-
ing as you pour the chemical into the tank and then fill the rest of the way.
You may use the handgun to spray into the solution in order to mix the
chemical and water.
After spraying, rinse and clean the equipment both inside and out. Flush
the pumping system with water.
Be sure to read the chemical label(s) before application!
After Spraying & Winter Storage
After use, fill the sprayer tank part way with water. Start the sprayer and
allow the clear water to be pumped through the plumbing system and out
through the spray nozzle. Refill the tank about half full with plain water and
use FIMCO Tank Neutralizer and Cleaner and repeat cleaning instructions
above. Flush the entire sprayer with the neutralizing/cleaning agent, then
flush out one more time with plain water. Follow the chemical manufactur-
er's disposal instructions of all wash or rinsing water.
WARNING:
Some chemicals will damage the plumbing components
if allowed to soak untreated for a length of time! ALWAYS
system as instructed after each use.
Drain all water out of your sprayer. Store in a place where temper-
atures will not be in the freezing range.
Proper care and maintenance will prolong the life of your sprayer.
[5008438
226103
flush the
(07/15)]
Page 1