Fimco LG-25-BL Owner's Manual

Owner's Manual

General Information

Thank you for purchasing this product. The purpose of this
manual is to assist you in operating and maintaining your lawn
& garden/ATV sprayer. Please read it carefully, as it furnishes
information which will help you achieve years of trouble-free
operation.
Warranty/Parts/Service
Products are warranted for one year from date of purchase
against manufacturer or workmanship defects.
Commercial users have a 90 day warranty.
Your authorized dealer is the best source of replacement parts
and service. To obtain prompt, efficient service, always
remember to give the following information...
- Correct Part Description and/or part number.
- Model number/Serial number of your sprayer.
Part descriptions and part numbers can be obtained from the
illustrated parts list section(s) of this manual.
Whenever you need parts or repair service, contact your
distributor/dealer first. For warranty work, always take your
original sales slip, or other evidence of purchase date, to your
distributor/dealer.
Model: LG-25-BL (5302183)
(25 Gallon ATV Dual Nozzle Sprayer)

Technical Specifications

• 25 Gal. Corrosion-Resistant Polyethylene Tank
• 12 Volt Diaphragm Pump, 3.8 g.p.m. - 45 p.s.i.
• Deluxe Pistol-Grip Handgun w/15 Ft. Handgun Hose
• 26 Ft. max. vertical throw, 35 Ft. max. horizontal throw
• Pressure Gauge
• Adjustable Pressure
• 28 Foot Spray Coverage w/(2) (Boomless) Nozzles
• Corrosion-Resistant Nozzles
Caution: Always check the vehicle load rating before using
this sprayer. Care must be taken not to tip the vehicle over
backwards, especially when starting or accelerating.
Assembly
1. Install the tank mounting plates to the tank as shown in the
exploded view drawing. (if not done so already)
2. Place the tank, with the brackets attached, to your ATV carrier
rack. Attach the mounting brackets to the cross members of the
rack, using the hardware supplied. (See exploded view drawing)
3. Join the nozzle mounts (RH & LH) to the tank mounting
brackets with the hardware shown.
4. Attach the nozzle assemblies to the nozzle mounts with the
(2) clips as shown. Make sure the u-bolts are fastened through
the bracket(s) and up into the tank mounting bracket(s). Connect
the (2) hoses to these nozzle assemblies. Secure with a hose
clamp. The other ends of these hoses get attached to the "Y"
valve on of the manifold. Each nozzle will have its own shut-off
valve control.
5. Thread the pressure gauge into the reducing bushing at the
far end of the manifold assembly. Use a good grade of thread
sealant, or teflon tape, to insure no leaks.
6. Connect the wiring harness to the rear of the pump. Clip the
alligator clip ends to a fully charged 12 Volt battery. Red wire to
the 'Hot' connection, and black wire to the 'Ground'.
www.fimcoindustries.com
1000 FIMCO Lane, P.O. Box 1700, North Sioux City, SD 57049
Toll Free Phone: 800-831-0027 : Toll Free Fax: 800-494-0440
[ Part Number: 5008348 (01/13) ] Printed in the U.S.A.