Operation Of Control Box; Hydraulic Feed Selector Operation; Spring Setting; Adjusting Movable Blade Guide - Axminster UV-180DS Instruction Manual

Operation of Control Box

2
1 3
Fig. 5
1. Emergency stop switch
Press down the Emergency switch to stop all of
machine function if any unsafely situation
occurred.
2. Stop power button
O: Press to disconnect the power of motor.
3. Power on button
I: Press to connect the power of motor
4. Blade speed adjusting knob
Variable blade speed is controlled by the knob.
Turn knob clockwise to increase speed from 25
to 85mpm. Turn knob counter clockwise to
decrease blade speed.
5. Cutting mode selection Switch
There is two cutting modes and neutral position
can be selected. Select any cutting mode the
power should be cut by the neutral position.
a. manual mode
b. Hydraulic flow controlled descend mode.
Turn switch left for hydraulic controlled
descend mode and right for manual mode.
6. Coolant ON/OFF Switch
I: Turn on the coolant
O: Turn off the coolant
P
Q
Fig. 4
4 5 6

Hydraulic Feed Selector Operation

The hydraulic feed selector is used to control
cutting feed down rate and lock the bow in the
proper position.
To turn off the flow of hydraulic fluid, pull lever (B)
to vertical with the cylinder.
To turn the hydraulic fluid on, pull lever (B) to
parallel with the cylinder.
Open hydraulic on (B), turn knob (A, Fig. 7)
counter-clockwise to increase the feed rate ;
decrease the feed rate, turn knob (A) clockwise.

Spring Setting

According to operation mode-manual or hydraulic
controlled descend mode, the spring need to be
readjusted as following instruction:
- Hydraulic control descend mode: Turn nut (A,
Fig.8) counter clockwise to the end to loose spring
tension, open hydraulic valve and adjust hydraulic
flow control knob to control saw frame down
speed.
- Manual mode: Open hydraulic valve and turn
hydraulic control knob counter clockwise to the
end to fully open the control flow, the saw frame
will down to the lowest location, turn handle nut (A,
Fig.8) clockwise to tension spring until bow can
rise up higher than vise jaw or material.

Adjusting movable Blade Guide

1. Disconnect machine from the power source.
2. Loosen lock handle A and knob B (Fig.9).
Slide blade guide assemblies as close as
possible to the material for cutting stably.
3. Tighten handle A and knob B after adjusting.
3
Fig. 7
Fig. 8
A
B
A