GE 21028 User Manual page 49

• The handset may be out of range of the base. Move closer to the base.
• You may have enabled Do Not Disturb (DND). Make sure the DND is off.
• You may have too many extension phones on your line. Try unplugging
some extension phones.
• Check for a dial tone.
You experience static, noise, or fading in and out
• The handset may be out of range of the base. Move closer to base.
• Make sure base is not plugged into an electrical outlet with another
household appliance. If necessary, relocate the base.
• Charge the battery (for 16 hours).
Unit beeps
• Clean the charging contacts on the cordless handset.
• See solutions for "No dial tone " on previous page.
• Replace the battery.
Memory dialing doesn't work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and no communication between the base and cordless handset
• Unplug the power supply from the electrical outlet and the back of the
base. Remove the handset battery. Wait for 30 seconds and plug the
power supply back into the base and electrical outlet. Reconnect the
battery and charge for 16 hours.
Handset displays " SEARCHING " or " OUT OF RANGE " and cannot link up
with the base when TALK/END/CALLBACK button is pressed.
• Handset may be out of range from the base. Move closer to the base.
• Make sure the power supply is properly installed.
• Disconnect the handset battery and plug it again. Place the handset on
the cradle for at least 2 to 3 minutes.
49