CTC Union FMC-10/100LF User Manual

Introduction
The FMC-10/100LF gives you the option to choose from the most
popular fiber cabling connectors by providing you with ST, SC or FC
connectors for your fiber optic cables and RJ-45 port for 10/100Base-TX
twisted pair cable connection. The factory default settings of Ethernet
auto-negotiation may be modified by adjustment of external DIP
switches to force Full/Half 10/100 or LLF (Link Lose Forwarding) function
settings.
The FMC-10/100LF gives you the freedom to extend your 10/100Mbps
cabling distance by allowing connectivity up to 120 kilometers over
fiber. Six LED indicators signal the power status of the converter, UTP
port speed, Link/Act, duplex status and FX port Link/Act and FEF (Far End
Fault).
s a l e s @ c t c u . c o m
Features
■ Figure#1. Upper Panel of FMC-10/100LF
DC Jack
DIP Switch
LAN Connector
DC
Jack
Figure#1. Converter Overview
s a l e s @ c t c u . c o m
w w w . c t c u . c o m
Fiber Connector
LED Indicators
Fiber
Connector
LED
Indicators
LAN
Connector
DIP
Switch
w w w . c t c u . c o m
CTC Union Technologies Co., LTD.
w w w
User Guide for
FMC-10/100LF
Fast Ethernet Over Fiber Media Converter
s a l e s @ c t c u . c o m

Specifications

■ Standards
IEEE802.3 10BASE-T, IEEE802.3u 100BASE-TX, 100BASE-FX (Fast Ethernet over Optical
Fiber, 100Mbps), supports Full Duplex Ethernet mode (200Mbps)
FMC-10/100 supports transmission of Ethernet packets up to 1600 bytes.
■ 10/100BASE-TX RJ-45 Connectors
One RJ-45 connector provides auto MDI/X function for connection to either
MDI-X (To PC) or MDI (To HUB) equipment. This allows all UTP connections to
be made using only a common straight-through UTP cable.
RJ-45 Pin MDI-X type
1 Rx+
2 Rx -
3 Tx+
6 Tx -
■
100Base-TX UTP Cable
Cable type: Category 5 or better
Maximum cable distance: 100 meters (328 feet)
■
Fiber Optic Connectors
For 1x9 fiber transceiver:
Two connectors are provided for fiber optic cable connection.
One is for transmission and the other is for reception of optical data.
For WDM type fiber transceiver:
One SC connector is provided for fiber optic cable connection.
For both transmission and reception of optical data.
Please note that transceiver type "A" (TX1310/RX1550) must connect to transceiver type "B"
(TX1550/RX1310) for proper fiber link.
Environment
o o
Temperature : 0 C – 50 C
Humidity: 5-95% non-condensing
Dimension (H x W x D)
FMC-10/100LF: 73 x 108 x 23 mm
s a l e s @ c t c u . c o m
. c t c u . c o
MDI type
Tx+
Tx -
Rx+
Rx -
Power
FMC-10/100LF
AC adaptor +12VDC / 400mA
DC plug type: Center Positive
AC input: 100~240VAC
Frequency: 47-63Hz
w w w . c t c u . c o m
m