Canon PIXMA MG5220 Service Manual page 17

15 times USB host Vbus
overcurrent
16 times Pump roller
sensor error
17 times Paper eject
encoder error
19 times Ink tank
position sensor
error
20 times Other errors
21 times Drive switch
error
22 times Scanner error
for Preventive Replacement of the
Ink Absorber."
(2) Jammed paper in the under guide:
Remove the jammed paper.
[9000] (1) Part replacement:
Replace the logic board ass'y.
[5C20] (1) Cable connection
Re-connect the cable.
[6010] (1) Smearing on the LF / EJ slit film:
Clean the LF / EJ slit film using lint-
free paper.
(2) Foreign material in the paper path:
Remove foreign material.
(3) Cable connection:
- LF encoder cable
- PE sensor cable
Re-connect the cable.
(4) Scratches on the LF / EJ slit film:
Replace the timing slit disk feed film
or the timing slit disk eject film.
[6502] (1) Ink tank position:
Confirm the ink tanks are installed in
the correct slots.
(2) Re-set or replacement of ink tanks:
If the error persists, replace the ink
tanks.
(3) Cable connection
Re-connect the cable.
[6500] (1) Cable connection:
- Wireless LAN cable
Re-connect the cable.
[C000] (1) Foreign material in the drive switch area
of the purge drive system unit:
Remove foreign material.
(2) Ink tank conditions:
Confirm that the ink tanks are seated
properly and they do not interfere
with the carriage movement.
[5011] (1) Cable connection:
- J900, J1002, J704
Re-connect the cable.
(2) Damper condition inside the scanner:
If the damper winds around the CIS,
replace the scanner unit.
(3) Scanner belt pulley:
If the pulley is dislocated, replace the
13 / 62
- Purge drive
system unit
- Timing slit disk
feed film
- Timing slit disk
eject film
- Timing sensor
unit
- Platen unit
- Logic board ass'y
- Paper feed motor
- Spur unit
- Logic board ass'y
- Logic board ass'y
- Wireless LAN
board ass'y
- Purge drive
system unit
- ASF unit
- Carriage unit
- Scanner unit
- Document
pressure sheet
- Logic board ass'y