Canon PIXMA MG5220 Service Manual page 11

Multiple ink [1487]
tanks of the
same color
installed.
Ink tank in a [1680]
wrong position.
Warning: The [1700]
ink absorber
becomes almost
full.
The connected [2001]
digital camera
or digital video
camera does not
support Camera
Direct Printing.
Automatic [1310]
double-sided
printing cannot
be performed.
U071 More than one ink
tank of the following
color is installed.
U072 Some ink tanks are
not installed in place.
--- The ink absorber is
almost full. Press
[OK] to continue
printing. Contact the
service center for
replacement.
--- Incompatible device
detected. Remove
the device.
--- This paper is not
compatible with two-
sided printing.
Remove the paper
and press [OK].
Replace the wrong ink
tank(s) with the correct
one(s).
Install the ink tank(s) in
the correct position.
Replace the ink absorber,
and reset its counter. [See
3-3, Adjustment and
Settings in Service
Mode.]
Pressing the OK button
will exit the error, and
enable printing without
replacing the ink
absorber. However, when
the ink absorber becomes
full, no further printing
can be performed unless
the applicable ink
absorber is replaced.
Remove the cable
between the camera and
the machine.
The paper length is not
supported for double-
sided printing.
Press the OK button to
eject the paper being used
at error occurrence.
Data which was to be
printed on the back side
of paper at error
occurrence is skipped
7 / 62
- Ink tank
- Ink tank
- Absorber kit
- Duplex paper feed
roller unit
- PE sensor board ass'y