Canon PIXMA MG5220 Service Manual page 15

4 times Purge cam
sensor error
5 times ASF (cam)
sensor error
6 times Internal
temperature
error
7 times Ink absorber
full
8 times Print head
temperature rise
error
9 times EEPROM error [6800]
10 times VH monitor
error
[5C00] (1) Foreign material around the purge drive
system unit:
Remove foreign material.
(2) Cable connection:
- LF encoder cable
- PE sensor cable
- Paper feed relay harness ass'y
- Paper feed motor harness ass'y
Re-connect the cable.
(3) Strange sound at power-on:
Replace the purge drive system unit.
[5700] (1) Cable connection:
- PE sensor cable, etc.
Re-connect the cable.
[5400] (1) Cable connection:
- Between the spur unit and the logic
board, J703 connector, etc.
Re-connect the cable.
[5B00] (1) Ink absorber condition:
[5B01] Replace the ink absorber, and reset
the ink absorber counter value in the
EEPROM.
[5200] (1) Print head condition (face surface and
mold):
If a burn mark or heat deformation is
seen on the face surface or the mold,
replace the print head.
(2) Head contact pin condition of the
carriage unit:
If the pin is bent or deformed,
replace the carriage unit.
(3) Cable connection:
- CR FFC (J500, J501, J502)
Re-connect the cable.
If any damage or breakage of the
cable is found, replace the carriage
unit.
(1) Part replacement:
[6801] Replace the logic board ass'y.
[B200] (1) Print head condition (face surface and
mold):
If a burn mark or heat deformation is
seen on the face surface or the mold,
replace the print head and the logic
board in set. (Be sure to replace them
at the same time.)
11 / 62
- Purge drive
system unit
- Logic board ass'y
- ASF unit
- PE sensor board
ass'y
- Logic board ass'y
- Spur unit
- Logic board ass'y
- Print head
- Absorber kit
- Print head
- Carriage unit
- Logic board ass'y
- Print head and
logic board ass'y
(replace them at
the same time)
- AC adapter
- Carriage unit