Maintenance; Accessories And Attachments - Porter-Cable PCB660DP Instruction Manual

WARNING
!
For your own safety, turn the switch off and
remove the plug from the power source outlet
before maintaining or lubricating your drill press.
GENERAL MAINTENANCE
Frequently blow out dust and grit that
accumulates in the motor housing using
compressed air.
WARNING
!
ALWAYS use safety glasses. Everyday
eyeglasses are NOT safety glasses. Also
use face or dust mask if cutting operation is
dusty. ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
● ANSI Z87.1 eye protection
(CAN/CSA Z94.3),
● ANSI S12.6 (S3.19) hearing protection,
● NIOSH/OSHA/MSHA respiratory
protection.
A coat of automotive paste wax applied to
the table and column will help to keep the
surface clean.

ACCESSORIES AND ATTACHMENTS

AVAILABLE ACCESSORIES
WARNING
!
Since accessories, other than those offered
by Porter-Cable, have not been tested with
this product, use of such accessories with
this tool could be hazardous. To reduce the
risk of injury, only Porter-Cable recommended
accessories should be used with this product.
A complete line of accessories is available
from your Porter-Cable Factory Service
Center or a Porter-Cable Authorized Warranty
Service Center. Please visit our Website
www.portercable.com for a catalog or for the
name of your nearest supplier.

MAINTENANCE

WARNING
!
To avoid shock or fire hazard, if the power lead
is worn or cut in any way, replace it immediately.
LUBRICATION
Ball bearings in the drill press are packed
with grease at the factory and require no
further lubrication.
Use only mild soap and a damp cloth to clean
the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance
and adjustment (other than those listed
in this manual) should be performed by
authorized service centers or other qualified
service organizations, always using identical
replacement parts.
To clean cast iron parts of rust, you will need
the following materials (not supplied): scouring
pad, spray lubricant, can of degreaser. Apply
the spray lubricant and polish with surface
with the scouring pad. Degrease the surface,
then apply a protective product such as an
automotive paste wax.
WARNING
!
Do not use any accessory unless you have
completely read the Instruction Manual for
that accessory.
24