Porter-Cable PCB660DP Instruction Manual page 16

2. Lower the spindle by turning the feed
handle (3) counterclockwise, until the
outer slot (4) appears on the quill (5).
(Fig. J)
3. Push the chuck (1) and spindle arbor (2)
up into the spindle, making sure the tang (6)
(upper narrow end of the spindle arbor
shank) is engaged and locked in the inner
slot (7) of the spindle. This can be seen
through the outer slot (4) of the quill by
rotating the chuck and arbor until the two
slots are aligned.
4. Open the jaws of the chuck (1) by
rotating the chuck sleeve clockwise. To
prevent damage, make sure the jaws are
completely receded into the chuck.
NOTE: Clean the taper with a non-alcohol
based cleaner before inserting it into
the arbor.
Fig. J
4
6
7
5
2
1
5. Using a rubber mallet, or a hammer and
a block of wood, firmly tap the chuck
upward into position on the spindle shaft.
Fig. K
3
CHUCK KEY STORAGE (FIG. L)
Storage holder (1) for the chuck key (2) is
located on the right side of the drill press.
Fig. L
INSTALLING THE BULB (FIG. M)
NOTE: Bulb is not included.
1. Install a light bulb (1) (no larger than
40 watt) into the socket.
WARNING
!
●
For your own safety, never connect
plug to power source outlet until all
assembly steps are complete and you
have read and understood the safety
and operating instructions.
●
To prevent injury resulting from heat of
the light bulb. Never touch the light bulb.
●
To prevent electric shock, never touch
the bulb socket when the plug is
connected to the power source.
Fig. M
ON/OFF SWITCH
ADJUSTMENT INSTRUCTIONS
NOTE: All the adjustments for the operation
of the drill press have been completed at the
factory. Due to normal wear and use, some
occasional readjustments may be necessary.
WARNING
!
To avoid injury from an accidental start,
ALWAYS make sure the switch is in the "OFF"
position, the switch key is removed, and the
plug is not connected to the power source
outlet before making adjustments.
16
1
1
2